Boss Laser recommends the use of an Air Filter / Water Separator to be used in conjunction with any air compressor that is part of the operating system for our laser machines. These filters are designed to remove water and solid contaminants from the compressed air. Without proper filtration these contaminants can reach the lens housing and result in premature failure of the focal lens.
Boss Laser’s Air Filter / Water Separator Kit provides the correct components required to install on all our LS & HP CO2 laser machines.
The Air Filter / Water Separator Kit includes:
- Air Filter Assembly with mounting bracket and thread seal tape.
- Air Fittings (Qty: 3) – 6mm tubing “Push-to-Connect”
- Tubing (Approx. 20 Ft) – 6mm black nylon
Note: Filter should be located approximately 20ft from the compressor